Microlite BackupEDGE Technical Support

Title

I set & exported the environment variable VOL_SWITCH_CMD for my autochanging tape drive.

Keywords

edge 4mm Autochanger tape drives edge.cfg VOL_SWITCH_CMD

Product Release(s)

01.00.0x 01.01.0x

Problem Description

I set & exported the environment variable VOL_SWITCH_CMD for my autochanging tape drive. The command issued works from the command line but not from edgemenu.

Cause

This is caused by an error in the documentation & an error in the environment variable definition in /etc/default/edge.cfg.

Solution

The variable is incorrectly identified in /etc/default/edge.cfg as VOL_SWITCH_CMD. A search of the edge binary shows it should have been SWITCH_VOL_CMD. Make the correction in /etc/default/edge.cfg, as well as in your manual (page 106). This will be corrected in later releases of BackupEDGE & in later printings of the manual.

Get a printer-friendly version of this document

Last Modified Tuesday, September 02, 2008
Site Content Copyright ©1999-2008 by Microlite Corporation. All Rights Reserved